Filter
Top Products
AIS
10-5
10.5 Displaying Target Data
10.5.1 Basic target data
1. Place the cursor on an AIS target symbol.
2. Press the [ENTER/SELECT] key to show the target’s basic data. The target is marked
as below.
Activated target selected for data display
AIS 02 TRUE VECT
1436782 6min BT
BRG 234.1
T
RNG 9.92NM
COG* 321.2
T BT
SOG# 21.1KT BT
CPA 2.8NM
TCPA 23:50
AIS target, fusion target no.
Call sign
Bearing from own ship to target
Range from own ship to target
Course over ground
Speed over ground
CPA
TCPA
* = CSE (course) when water tracking mode is selected at radar.
# = STW (speed thru water) when water tracking mode is selected at radar.
AIS target vector
orientation
(TRUE or REL)
Vector length;
BT: Bottom Tracking
or
WT: Water Tracking
Basic data display
Note 1: You may also show basic data by pressing the [F2] key followed by the [3] key
(Basic Data). Basic data is hidden by the AIS(1) menu; close the AIS(1) menu to
show basic data.
Note 2: If an ARPA symbol is hidden beneath and AIS symbol, press the [ENTER/SELECT]
key to display ARPA data. In this case, use 3. Basic Data (or [F2] key programmed
for “33. AIS DATA) on the AIS(1) menu to display AIS data.