Filter
Top Products
8-8
13)Press the [NU/CU ENT] key. The mes-
sage shown in Figure 8-13 appears.
Now loading
Waypoint/Route data !
MENU:Stop
Figure 8-13
14)Operate the computer to output data.
When data is loaded, the cursor shifts to
Stop.
15)Press the [MENU ESC] key. When data
is loaded successfully, The message in
Figure 8-14 appears.
Loading ended successfully
Press any key
Figure 8-14
If data could not be loaded, the message
shown in Figure 8-15 appears.
Failed in loading
Invalid data
Press any key
Figure 8-15
Stopping loading of data
1) Press the [MENU ESC] key. The message
shown in Figure 8-16 appears.
Are you sure to stop ?
ENT: Yes MENU:No
Figure 8-16
2) To quit loading, press the [NU/CU ENT]
key. The cursor shifts to Stop.
3) To start loading, select Start.
4) Press the [NU/CU ENT] key.
Loading waypoint data from
YEOMAN equipment
1) Do steps 1 through 9 in "Loading light-
house data."
2) Press t or s to select WPT.
3) Press ▼ to select Command.
4) Press s to select Start. The message
shown in Figure 8-17 appears.
Are you sure to load ?
ENT: Yes MENU:No
Figure 8-17
5) Press the [NU/CU ENT] key. The mes-
sage shown in Figure 8-18 appears.
Now loading
Waypoint data !
MENU:Stop
Figure 8-18
6) Operate the YEOMAN to output data.
When data is loaded, the cursor automati-
cally shifts to "Stop". Waypoints are
loaded into empty areas. When the
waypoint area becomes full, the message
shown in Figure 8-19 appears.
Waypoint area is full !
Can't load any data
Press any key to stop
Figure 8-19
7) When the data is loaded, press [CU/NU
ENT] and [MENU ESC]. The message
shown in Figure 8-20 appears.
The number of valid and invalid
waypoints appears in the message.
Loading completed
Valid waypoint : 0
Invalid waypoint : 0
Press any key
Figure 8-20