Filter
Top Products
3–3
Can't save event/MOB
No position data
Figure 3-7
To enter an event mark;
1) Press the [EVENT MOB] key less than
three seconds. The position at the exact
moment the key is pressed is saved as an
event position.
Saved event position
34°40.123’ N
135°21.123’ E
Figure 3-8
To erase event marks, see "3.2 Erasing
Marks".
3.6 Event Mark Shape
Event marks are available in 9 shapes.
Event mark shape is mutually changed when
the navigators are sharing data.
Select event mark shape as follows.
1) Press [MENU ESC] and [2] to display the
TRACK/MARK SETUP menu.
2) Press ▲ or ▼ to select Event Mark.
3) Press t or s to select event mark shape
desired.
4) Press the [NU/CU ENT] key.
5) Press the [MENU ESC] key.
The next event mark entered will be inscribed
in the shape selected here.
3.7 Entering the MOB Mark
The MOB mark denotes man overboard po-
sition. To mark man overboard position, press
the [EVENT MOB] key. When the key is
pressed, the position at the exact moment the
key is pressed automatically becomes the des-
tination. Further, the Plotter 1 display replaces
the display in use when it is other than a plot-
ter display.
Only one MOB mark may be entered. Each
time the MOB mark is entered the previous
MOB mark and its position data are written
over. The MOB mark is mutually entered
when the navigators are sharing data.
Note: The MOB mark cannot be entered
when there is no position data. When this oc-
curs, the buzzer sounds and the message
shown below appears on the display for three
seconds to alert you. Check the antenna cable
for tight connection.
Can't save event/MOB
No position data
Figure 3-9
1) Press the [EVENT MOB] key for at least
three seconds.
The MOB mark ("M") is entered at the
MOB position and the message shown in
Figure 3-10 appears.
Saved MOB position
Are you sure to change course
to MOB position ?
ENT: Yes MENU: No
Figure 3-10
2) Press the [NU/CU ENT] key. If the dis-
play in use is Highway, Navigation or
Data, they are automatically replaced by
the Plotter 1 display.
Note: You may cancel MOB position as des-
tination by pressing the [MENU ESC] key
instead of the [NU/CU ENT] key at step 2.
Note that the MOB mark remains on the dis-
play.