Filter
Top Products
2–4
Are you sure to erase ?
ENT: Yes MENU: No
Figure 2-6 Prompt for
erasure of track, mark
5) Press the [NU/CU ENT] key.
2.8 Track Plotting Interval
The plotting interval determines both how the
track will be reconstructed on the display and
track storage time. A shorter interval provides
more accurate reconstruction of track line,
however total storage time is reduced. The
plotting interval can be selected by time or
distance. Plotting by distance offers the ad-
vantage that the track is not stored when the
vessel is anchored.
Plotting interval by time
The setting range for plotting by time is 00 to
60 minutes.
1) Press the [MENU ESC] key.
2) Press [2] to display the TRACK/MARK
SETUP menu.
TRACK/MARK SETUP
Track Rec
Mark Shape
Mark Line
Event Mark
Time
(01'00)
Dist
(00.50nm)
: Select
ENT: Enter
MENU: Escape
Figure 2-7 TRACK/MARK SETUP menu
3) Press ▲ or ▼ to select Track Rec.
4) Press t to select Time.
5) Enter plotting interval in four digits. To
enter 30 seconds, for example, press [0]
[0] [3] [0].
6) Press the [NU/CU ENT] key.
7) Press the [MENU ESC] key.
Plotting interval by distance
The setting range for plotting by distance is
0.01 to 99.99 nautical miles. To plot all track,
enter 00.00.
1) Press the [MENU ESC] key.
2) Press [2] to display the TRACK/MARK
SETUP menu.
3) Press ▲ or ▼ to select Track Rec.
4) Press s to select Distance.
5) Enter plotting interval. To enter 0.1 nauti-
cal miles, for example, press [0] [0] [1].
6) Press the [NU/CU ENT] key.
7) Press the [MENU ESC] key.