Filter
Top Products
1–7
2) Press the [9] key to display the SYSTEM
SETTINGS menu.
2. UNIT SETUP
SYSTEM SETTINGS
1. PLOTTER SETUP
2. UNIT SETUP
3. DATA 1, 3 OUTPUT SETUP
4. DATA TRANSFER
5. DATA 4 I/O SETUP
6. GPS SETUP
7. DGPS SETUP
8. LOP SETUP
9. CLEAR MEMORY
2. UNIT SETUP
ENT: Enter
MENU: Escape
Figure 1-13 SYSTEM SETTINGS menu
3) Press the [4] key to select DATA TRANS-
FER.
DATA TRANSFER
Transmit Data
All Stop Start
: Select
ENT: Enter MENU: Escape
Figure 1-14 DATA TRANSFER menu
4) Press s to select All and press the [NU/
CU ENT] key. The following message
appears. Press the [NU/CU ENT] key to
transmit, or [MENU ESC] to escape.
Are you sure to transmit ?
ENT: Yes MENU: No
Figure 1-15
The following message appears while data
is being transmitted.
Now transmitting data
MENU: Stop
Figure 1-16
5) To stop transmitting data, press the
[MENU ESC] key. The following display
appears.
Are you sure to stop ?
ENT: Yes MENU: No
Figure 1-17
Press the [NU/CU ENT] key to stop. In
this case, data is partially transmitted to
the other GPS navigator. You should fol-
low "Transmsitting data" in this paragraph
to transmit data again.
6) The following message appears when data
was transmitted successfully.
Transmitting ended
successfully
Press any key
Figure 1-18
7) Press any key to escape.
8) If transmission failed, transmission is
stopped and the following message ap-
pears.
Failed in transmitting
Try again please
Press any key
Figure 1-19
9) Press any key to return to the DATA
TRANSFER menu and select Stop. Since
data will be not the same on both GPS
navigator, repeat this procedure from step
4 until data is successfully transmitted.