Filter
Top Products
4–4
_ _°
Edit = Waypoint : 001
Mark :
Cmnt :
ENT: Enter
MENU: Escape
: Column
: Cursor
__
_ _._ _ _' N _ _ _°_ _._ _ _' W
Figure 4-11
6) Enter latitude and longitude. To enter
34°12.345' N 135°23.456' E, for example,
press;
([
]) [3] [4] [1] [2] [3] [4] [5]
([
]) [1] [3] [5] [2] [3] [4] [5] [6]
To change N to S or E to W, press [
].
7) Press ▼.
8) Press t or s to select mark.
9) Press the [NU/CU ENT] key.
10)Enter comment.
11) Press the [NU/CU ENT] key twice.
The waypoint list reappears. Waypoint
position and date and time the waypoint
was entered appear on the list.
12)To enter another waypoint through the
waypoint list, return to step 4.
13)Press the [MENU ESC] key to finish.
4.2 Editing Waypoints
Waypoints are mutually edited when the navi-
gators are sharing data.
1) Press [WPT RTE] and [4].
2) Press ▲ or ▼ to select waypoint to edit.
3) Press s.
4) Edit the contents of the waypoint.
5) Press the [NU/CU ENT] key. The mes-
sage shown in Figure 4-12 appears if the
waypoint is currently selected as destina-
tion, is part of a route, or is in the route
currently selected as destination.
This wpt is GOTO
This wpt is in registered route
This wpt is in selected route
1st line
Are you sure to erase ?
ENT: Yes MENU: No
Figure 4-12
6) Press the [NU/CU ENT] key.
The waypoint and its data are erased. En-
ter new data, referring to "4.1 Entering
Waypoints".
7) Press the [MENU ESC] key.
4.3 Erasing Waypoints
Waypoints are mutually erased when the navi-
gators are sharing data.
Erasing waypoints by the cursor
1) Place the cursor on the waypoint to erase.
2) Press the [CLEAR] key.