Filter
Top Products
3–2
Are you sure to erase ?
ENT: Yes MENU: No
Figure 3-4
4) Press the [NU/CU ENT] key.
5) Press the [MENU ESC] key.
3.3 Mark Shape
12 mark shapes are available. Select mark
shape as follows:
1) Press [MENU ESC] and [2] to display the
TRACK/MARK SETUP menu.
TRACK/MARK SETUP
Track Rec
Mark Shape
Mark Line
Event Mark
Time
(01'00)
Dist
(00.50nm)
: Select
ENT: Enter
MENU: Escape
Figure 3-5 TRACK/MARK SETUP menu
2) Press ▲ or ▼ to select Mark Shape.
3) Press t or s to select mark shape de-
sired.
4) Press the [NU/CU ENT] key.
5) Press the [MENU ESC] key.
The next mark entered will be inscribed in
the shape selected here.
3.4 Connecting Marks
Marks can be connected with lines to denote
net location, fishing spot, etc. Three types of
connection lines are available and the "•" set-
ting disables connection of lines.
1) Press [MENU ESC] and [2]
2) Press ▲ or ▼ to select Mark Line.
3) Press t or s to select mark line de-
sired.
4) Press the [NU/CU ENT] key.
5) Press the [MENU ESC] key.
3.5 Entering Event Marks
Event marks can denote any important present
position; for example, a good fishing spot. 99
event marks can be saved, and the unit auto-
matically numbers them from 01 to 99.
Event marks are mutually entered when the
navigators are sharing data.
Note 1: When the mark memory becomes full
no event marks can be entered. When this oc-
curs, the buzzer sounds and the message
shown below appears on the display for three
seconds to alert you. To enter an event mark
when the mark memory is full, erase unnec-
essary event marks.
Can't save event
Memory full
Figure 3-6
Note 2: Event marks cannot be entered when
there is no position data. When this occurs,
the buzzer sounds and the message shown
below appears on the display for three sec-
onds to alert you. Check the antenna cable for
tight connection.