Open as PDF
indicating that the active and hold status of the two calls
have switched. Only one call can be placed on hold at one
When two calls are in progress (one active and one on
hold), press and hold the ’Phone’ button until you hear a
double beep indicating that the two calls have been
joined into one conference call.
To initiate three-way calling, press the ’Voice Recogni-
tion’ button while a call is in progress and make a second
phone call as described under ЉMaking a Second Call
while Current Call in Progress.Љ After the second call has
established, press and hold the ’Phone’ button until you
hear a double beep indicating that the two calls have
been joined into one conference call.
To end a call in progress, momentarily press the ЈPhone’
button. Only the active call(s) will be terminated and if
there is a call on hold, it will become the new active call.
Press the ’Phone’ button to begin.
After the ЉReadyЉ prompt and the following beep, say
The UConnect™ system will call the last number that
was dialed on your cellular phone. Note: this may not
be the last number dialed from the UConnect™ sys-
Call continuation is progression of a phone call on
UConnect™ system after the vehicle ignition key has
been switched to off. Call continuation functionality
available on the vehicle can be any one of three types:
144 UNDERSTANDING THE FEATURES OF YOUR VEHICLE