Filter
Top Products
Voice Editor 7-2
B1272M001 BARNETT ENGINEERING LTD. ProTalk Cv2
Controls in the Voice Editor dialog box are:
Individual Voice Phrase Section
Hardware
The setting of the tab control at the bottom of the box determines which part of
the message configuration is shown in the phrase list boxes.
Use Text Names
This check box controls the display of the text names (Site Name, Point Name and
Group Name) that are in the background programming session. Turning this
function on is only of use if the text names match the phrases in the current voice
editing session. Information is these text fields is for reference and is not used by
the Cv2.
Site ID Tab
A single text line displaying the current status of the Site ID phrase.
Depending on what has been loaded into the editor, one of the following will
appear in the location for the Site ID phrase.
empty the location contains no phrase data
in .msg file the phrase is contained in a loaded message file
<File path\file name> the phrase is in an individual file has been loaded
at this location
Groups Tab
A 6 line list box displaying the current status of the group phrases.
Contents of each line is as described for the Site ID above.
Points Tab
A 30 line list box displaying the current status of the point phrases.
Contents of each line is as described for the Site ID above.
Load
The position in the list where the phrase is to be used must be selected before
pressing this button. A File Open dialog box is used to select the required file.
The file type has the extension .vox and must have either been processed by the
wave converter or previously extracted from a message file.
Clear
The position in the list where the phrase is to be removed must be selected before
pressing this button.
Save
The location for the phrase that is to be saved must be selected before pressing
this button. A File Save dialog box is used to set the file name and location. The
saved file is extracted from the currently loaded message file and saved with the
.vox extension.