Filter
Top Products
Voice Storage and Configuration with the Telset 6-2
B1272M001
BARNETT ENGINEERING LTD. ProTalk Cv2
Directory programming, where the called numbers are entered, requires care to ensure that
these numbers are valid. If the Cv2 is unable to successfully complete calls it will take
action to ensure that the cellular network is not adversely affected. These actions are
detailed in the “Getting Started” section at the beginning of the manual.
The following example shows how to enter voice messages using a telephone set.
Cv2: “Enter Program Code”
1rr - Voices
Cv2: “Enter Voice Code”
After the Cv2 responds with this prompt it waits for you to enter a selection from the
voice menu. The choices at this point are:
1rr - Record or Play Back Site ID and Group Voices
Cv2: “Site ID is Ajax Compressor Station”
(The first time the site ID, or any other voice message, is programmed, the Cv2 will
have either no voice message or a factory test message.)
To record the new site ID, press 2rr and speak the desired name after the prompt
‘beep’ is returned.
The Cv2 detects when you stop speaking, and automatically plays back the message.
Pauses between words may cause the recording to terminate.
If the message is acceptable, press rr to advance to the next voice.
If it is not, keep using 2rr and repeat the message until it is satisfactory, then press
rr to accept the current recording. The next prompt you will hear is:
Cv2: “Group One is Electrical” (Group voices are not used in Basic mode)
Again, use 2rr to record the name of the group, and rr to advance. The Cv2 will
automatically advance through all six groups, then return to the “Enter Program Code”
prompt.
If you don’t need to go through all the groups, press #rr at any time to go back to the
main menu (“Enter Program Code” prompt).
4rr - Record or Play Back Points Voices
Cv2: “Point One is Power Failure”
As with the Site and Group IDs (Program Code 1), press 2rr to record a new voice
message, rr to advance to the next voice, or #rr to exit to the main menu.
Unless you exit, the Cv2 will automatically advance through all the enabled points, then
back to the main menu.
5rr - Erase Voices
Cv2: “Enter Empty Code”
Press #31rr to confirm that you want to erase all voices.