Filter
Top Products
Voice Storage and Configuration with the Telset 6-3
B1272M001
BARNETT ENGINEERING LTD. ProTalk Cv2
6.4 Telset Programming Summary
A Cv2 is set for Basic mode programming when it is shipped. The only way to change it to
the Advanced mode is by using the PC configuration software.
The different sequence of prompts and the variables that can be accessed in each mode are
shown in the flow chart.
When editing Directories in Advanced mode the commands are entered in the same format
as they appear on the summary screen on the PC. The following codes correspond to the
commands found on the PC programming screen:
[DIAL] [VOICE]
[WAIT] [SIGNAL]
[AUTO ACK] ‘!’ 2 second pause in Dial or DTMF
[DTMF] ‘#’ digit
[ALERT] Accept
[ANSWER]
Directory entries in Basic mode consist of the telephone number followed by rr. This is
the equivalent of #0 <telephone number> #6 rr in Advanced mode. The Cv2 will accept
either entry method regardless of which programming mode is being used.