Filter
Top Products
C3 RS1100REV. A
30
5. The remote start feature programming has not been programmed to start the
vehicle. The remote start must be programmed how to start the vehicle.
SHUTDOWN DIAGNOSTICS
The unit has the ability to report the cause of the last shutdown of the remote start
system.
Enter:
1. Turn the Ignition switch to ‘ON position.
2. Press the button on the transmitter.
3. The LED will now report the last system shutdown by flashing for one minute in the
following grouped patterns:
LED
Flashes
Shutdown Mode
1 (-) Safety Shutdown input (Hood)
1. Close the hood.
2. Check H6/14 White/ Black wire connection.
2
(+) Safety Shutdown input (Brake)
or
Neutral Safety Switch input fail.
1. Check H6/18 White/ Violet wire connection.
2. Move the Enable Toggle Switch to “ON”
position. (If installed.)
3. Move the gear selector to “Park”/
“NEUTRAL” position.
4. Check H6/8 Black/White wire connection.
3
No RPM or
Low Voltage.
Tachometer Checking Type:
Check H6/10 White/Red wire connection
Voltage Checking Type:
Program the “CHECK LEVEL” from
“Hi Check Level” to “Low Check Level”
4 Wait-to-Start time out
Please check H6/13 White/ Gre en wire
connection
5 Over-rev
6 System timed out
7 Transmitter
8
Tach. Signal has not been
learned
Re-learning the RPM (Start Feature
E – 2 /
3)
TESTING YOUR INSTALLATION:
Caution!! The follow procedure must be performed after the installation of the Remote
Start Device. It is the responsibility of the installing technician to complete these tests.
Failure to test the unit in the following manner may result in personal injury, property
damage, or both.
1. Test the BRAKE shutdown circuit: With the vehicle in park (P), start the vehicle using
the remote transmitter. Once the engine is running, press the brake pedal. The
vehicle should shut down immediately. If the vehicle continues to run, check the
brake circuit WHITE/ VIOLET wire (H6/1 8) connection.
2. Test the HOOD PIN shutdown circuit: Start the vehicle using the remote transmitter,
Once the engine is running, pull the hood release and raise the hood. The vehicle
should shut down immediately. If the vehicle continues to run, check the hood pin
WHITE/ BLACK wire (H6/20) connection.