Filter
Top Products
C3 RS1100REV. A
15
To + 12 V
Ignition
Switch
YELLOW wire
Matching Resistor
VATS control Module
87a
86
30
87
85
VAT wire (#1)
VAT wire
(#2)
H6/15 Green wire – Negative Door Switch Sensing Input (Zone 3) –
This wire is the ground trigger input wire for negative door pin switch. This wire is
connection for "grounding" type factory door pins locate the "common wire" that
connects the door pin switches. Make the connection of the GREEN Wire here.
H6/16 Gray wire – (-) 200mA Channel 2 (Trunk) Output –
This will become a 1 second pulse ground by activate (button 3) on transmitter
for two seconds, the current capacity of this wire is 200 mA. This feature allows you
to remote control trunk release or other electric device. (Realay may be required).
H6/17 Blue wire – Ground Instant Trigger Input (Zone 2) –
This wire is the ground trigger input wire for hood and or trunk pin switches.
H6/18 White / Violet wire – Positive Safety Shut Down Input –
H6/19 Violet wire – Positive Door Switch Sensing Input (Zone 3)–
This wire is the positive trigger input wire for positive door pin switch. This wire is
connection for "positive" type factory door pins(typical FORD MOTOR). Locate the
"common wire" for all door pins and make the connection of the VIOLET Wire here.
H6/20 White / Black wire – Negative Safety Shut Down Input –
This wire provides an instant
shutdown for the remote start,
whenever it gets +12volts. If the brake
lights switch in the vehicle switches
+12 volts to the brake light circuit,
connect this wire to the output side of
the brake switch. This will allow the
remote start to shut down if an
attempt is made to operate the
vehicle without the key while running
under the control of the remote start.
In most vehicles, in order to shift
gear, the brake pedal must be
depressed. The brake input will in
turn cause the remote start unit to
shut off. See diagram.
+12 volts from fuse box
To White/ Violet
wire
Brake light bulbs
Switch closes
When brake is
depress