Filter
Top Products
C3 RS1100REV. A
23
Note 1 :
If your built-in timer controls window/sunroof closure in your car DO NOT change the
timer setting! This requires installer-only programming. Changing the value will
adversely effect operation and may cause damage.
Note 2:
Momentary output = The momentary output selection will send a negative signal from the
Channel 4 output immediately when the channel 4 ( 5,6 ) button is pressed and will continue until
the button is released.
Latched output = The latched output selection will send a negative signal as soon as the
Channel 4 button is pressed and will continue until the button is pressed again.
Latched output / reset with ignition = The latched / reset with ignition output selection
operates just like the latched output but will reset or stop when the ignition is turned on.
Password Pin Code Setup:
Enter:
1. Turn the Ignition 'switch ‘ON/OFF’ 3 times and stay in OFF position.
2. Push the Valet switch 7 times (holding in on the 7th push) until three chirps with
one long chirp is heard then release the valet switch. You are now in the Alarm
feature “C” programming mode. You can program or delete the password pin code
as below:
Program:
1. Press and release the transmitter button twice, [2] LED flash, [2] siren/horn
chirp to indicate that you are in features “Password Pin Code Programming mode”.
2. Within 5 seconds, begin to enter your chosen first 9ths digit by pressing and
releasing the valet Switch from 1 – 9 times.
3. Within 15 seconds of the last entered 9ths digit, turn the Ignition switch to “ON”
position.
4. Within 15 seconds, enter your chosen second 9ths digit by pressing and releasing
the valet Switch from 1 – 9 times.
5. Finish by turning the ignition switch to “OFF” position.
If the new password code was accepted, the unit would report back the newly entered
code, by flas hing the LED, first indicating the first digit code has been memorized,
pause and then the second digit code. The unit will report the new code three times
with a one-second’s pause between each code.
Note: If 15 seconds of inactivity expire, or if the ignition switch is turned “ON” for more
then 5 seconds during of above steps, the unit will revert back to the last successfully
stored code. A [3] long chirps to confirm exit. Will revert back to the last successfully
stored code
Delete Password Pin Code / Override Without Password Pin Code (Factory default
setting):
Within 15 seconds, press and hold the transmitter button for 3 seconds. One
long chirp is heard to confirm Deleted the Password Pin Code.
Example: To program the Password Code 92, you would;
Enter:
1. Turn the Ignition 'switch ‘ON/OFF’ 3 times and stay in OFF position.
2. Push the Valet switch 7 times (holding in on the 7th push) it until three chirps with
one long chirp is heard then release the valet switch. You are now in the Alarm
feature “C” programming mode.