Filter
Top Products
C3 RS1100REV. A
13
Also on certain BMW, Mercedes Benz, Jaguar and Volkswagen cars, you can use this
unique timed output to allow remote closure of all power window and sunroof without the
need for an external module!
H6/12 Blue / Black wire – (-) 200mA Accessory 2 Output –
This wire provides a 200mA (-) ground output. This output will energize when the
remote start is activated, go away while the starter is cranking, and then come back
on when the vehicle has started successfully.
87
87a
85
30
86
IN4003 Diode
H10/19
: Orange/White wire
from control module
“Start”
“On”
X
Cut
“Acc”
“Off”
H1/4
Yellow wire (Ignition 1 output)
form Heavy Gauge wire harness
To Ignition Coil
H6/13 White / Green wire – (-) Diesel Wait To Start Input
(See Start Feature D - 1 Programming)
In diesel vehicles it is necessary to interface with the wire that on the
WAIT-TO-START light in the dashboard. This wire illuminates the bulb until the
vehicle’s glow plugs are properly heated. When the light goes out the vehicle can be
started. This wire is always at the connector leading to the bulb in the dashboard. It
can also be found at the Engine Control Module (ECM) in many vehicles.
To test and determine the polarity of this wire:
1. Set your multi-meter to DCV or DC voltage (12V or 20V is fine).
2. Attach the (+) probe of the meter to (+) 12V.
3. Probe the wire that you suspect leads to the bulb with the (-) probe of the meter.
4. Turn the ignition switch to the ON position.
5. If the meter indicates 12 volts until the light goes out you have isolated the
connect wire and the wire’s polarity is negative (ground while the bulb is on).
6. If the meter reads zero volts until the light goes out and then reads 12 volts, you
have isolated the connect wire and the wire’s polarity is positive.
Connect this wire to the wire in the vehicle that sends the signal to turn on the
WAIT-TO-START bulb in the dashboard. In most diesels the wire is negative (ground
turns on the bulb) and this wire can be directly connected to the wire in the vehicle. If
the vehicles use a positive wire (12V to turn the bulb) a relay must be used to
change the polarity.
(-) Wait To Start Wire
Wait to Start
Indicator
Ignition (+)
White/Green
Wire
Wait To Start Input
87a
86
87
30
85
(+) Wait To Start
Wait To Start
Indicator
White/Green Wire
Wait To Start Input
H6/14 Yellow wire – (-) 200mA Ignition 3 Output –