Filter
Top Products
C3 RS1100REV. A
10
H6: 22 PIN WIRE CONNECTORS:
H6/1 BROWN/BLACK WIRE: 200 mA (-) Ground Output When Running.
This wire provides a negative output during the remote start process. It can be used to
operate by-pass modules that may be required in your installation. This wire will provide
ground once the remote start process has been initiated and will remain grounded while the
engine is running
H6/2 GRAY/BLACK WIRE: 200 mA (-) Second Starter Output.
This line can be used if a second starter line is needed. Some vehicles require
a two-starter line to remote start. This wire provides a negative output that will
work the same way as the Violet starter line in connector H1.
H6/3 Pink wire – (-) 200mA Programmable Output 2 Steps Unlock Output (Factory
default setting) (See Alarm Feature C – 1 Programming)
The 2 steps unlock feature will work for the most fully electronic door lock circuit.
The vehicle must have an electronic door lock switch (not the lock knob or key
switch), which locks and unlocks all of vehicle's doors. When wired for this feature,
press the disarm (or unlock) button one time will disarm the alarm and unlock the
driver's door only. If, press disarm (or unlock) button two times within 3 seconds,
the alarm will disarm and all doors will unlock.
Factory Security Disarm Signal Output –
This wire is designed to disarm a factory installed security system. This wire
sends a negative (-) 1 seconds pulse upon a remote start and remote door
unlocking. Some factory systems must be disarmed to allow remote starting. In
most cases, this wire may be connected directly to the factory alarm disarm wire.
The correct wire will show negative ground when the key is used to unlock the
doors or trunk. This wire is usually found in the kick panel area in the wiring
harness coming into the car body from the door.
Start Status (Shock Sensor By-Pass Control) Output–
This wire is designed to by-pass shock sensor module. This wire will supply an
output at all times the remote start is operating plus an additional 3 seconds after
the remote start unit turn off.
Key Sensor By -Pass Output –