Filter
Top Products
C3 RS1100REV. A
25
6 +
Temperature-
Control Starting
OFF
Temperature-Co
ntrol Starting
“ON”
0 ºF / -18 ºC
Temperature-Cont
rol Starting “ON”
15 ºF / -9 ºC
7 +
Press
button = Activate
Remote Start.
Press -
button =
Activate Remote
Start.
Press +
button =
Activate Remote
Start.
8 +
H6/4 White/Blue
wire=
1 pulse activate
H6/4 White/Blue
wire =
2 pulse activate
H6/4 White/Blue
wire =
3 pulse activate
Exit: Turn Ignition to 'ON' position, or leave it for 15 seconds. 3 long chirps & 3 parking
light flashes will confirm exit.
SAFE START (Child safety mode)
Factory defaults setting to press the button once to start the vehicle.
Programming this feature to eliminate an accidental remote start,
1. The user presses the transmitter buttons “twice” within 3 seconds to start the
vehicle. or
2. The user presses the transmitter and buttons at the “same time” to start
the vehicle.
START FEATURE “E” PROGRAMMING:
1. Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2. Push the Valet switch 11 times (holding in on the 11
th
push) until five chirps with
one long chirp is heard then release the valet switch. You are now in the Start
feature “E” programming mode.
3. Press and release the transmitter button corresponding to the feature you want to
program.
Press
Transmitter
Button
One Chirp /
LED one pulse
Factory Default
Setting
Two Chirps /
LED two pulse
Three Chirps /
LED three pulse
Four Chirps /
LED four pulse
1
Exit the programming mode. (3 long chirp & 3 parking light flashes to confirm
this exit.)
2 +
Tachometer
Check type (3A)
Voltage check
type (go to 3B)
Timer checking
type (go to 3B)
Data Bus
Interface
Mode**
3
A> RPM learning – see RPM Learning page 26.
B> Start Crank
Time:
0.6-second
0.8-second (2 chirps), 1.0-second (3 chirps), 1.2-second (4
chirps), 1.4-second (5 chirps), 1.6-second (6 chirps),
1.8-second (7 chirps), 2.0-second (8 chirps), 3.0-second (9
chirps), 4.0-second (10 chirps),
4
Low check level Hi check level
5
Start or Stop the system for TESTING & ADJUSTMENT