Filter
Top Products
C3 RS1100REV. A
11
This output is for a Key Sense wire by -pass that some Chrysler and Toyota vehicles need
to activate remote start. This wire comes on when remote start is activated and stays on
for 20 seconds.
H6/4 White / Bule wire – (-) Instant Start & Turn Off Input –
This wires activates and turns off the remote starter each time it sees a momentary
ground signal. Normally used for testing during installation or when activating the
module from an after-market system.
H6/5 White wire – (-) 200mA Dome Light Control Output –
This wire becomes grounded when
the dome light controls circuit active.
The current capacity of this wire is
200mA. This wire can control the
operation of the interior lights. An
optional 10 Amps relay can be used to
this system for interior lights
operation.
87a
86
87
30
85
Fuse
White Wire
+12V
Door
Switch
Courtesy
Light
a). Upon disarming, the interior lights will remain on for 30 seconds.
b). If the alarm is triggered, the interior light will flash for the same duration as the
siren.
H6/6 Brown / White wire – (-) 200mA Programmable Output Horn Output –
(Factory default setting)
This wire is provided to use the existing
vehicle's horn as the alarm system's
optional's warning audible device. It's a
transistorized low current output, and
should only be connected to the low
current ground output from the vehicle's
horn switch. When the system is
triggered, the horn will sound.
85
86
87
87a
30
Brown/White
wire
To horn
+ 12 V
+12V Or Ground
Depending On System
Requirements
FUSE
Factory Security Rearm Signal Output –(See Alarm Feature C – 2 Programming) –
This output is programmable. If programmed rearm a factory installed security
system. This wire will supply a pulse whenever the remote start times out or is shut
dowm using the transmitter and remote door locking.
H6/7 Black/Green wire – (-) 200mA Timer Control Channel 4
See Alarm Feature C – 5 Programming) Channel 4 Output (Factory default
setting on momentary grounded)
This wire is built-in user-programmable timer output provides a ground through this
wire. Press the transmitter and buttons at the same time. You may program
the built-in timer to send a ground signal for any time interval between 1 second and
2 minutes. For instance, this timer output may be used to turn on the headlight with
the remote control. Also on certain BMW, Mercedes Benz, Jaguar and Volkswagen
cars, you can use this unique timed output to allow remote closure of all power
window and sunroof without the need for an external module!
H6/8 Black/White wire – (-) Neutral Safety Switch Input or (-) Enable Switch Input –