Filter
Top Products
3-34
TIRE PRESSURE CHECK/SPOKES INSPECTION AND
TIGHTENING/WHEEL INSPECTION
INSP
ADJ
EC36Q000
TIRE PRESSURE CHECK
1. Measure:
9Tire pressure
Out of specification → Adjust.
NOTE:
9Check the tire while it is cold.
9Loose bead stoppers allow the tire to slip off its
position on the rim when the tire pressure is
low.
9A tilted tire valve stem indicates that the tire
slips off its position on the rim.
9If the tire valve stem is found tilted, the tire is
considered to be slipping off its position.
Correct the tire position.
EC36S002
SPOKES INSPECTION AND TIGHTENING
1. Inspect:
9Spokes 1
Bend/Damage → Replace.
Loose spoke → Retighten.
2. Tighten:
9Spokes
NOTE:
Be sure to retighten these spokes before and af-
ter break-in. After a practice or a race check
spokes for looseness.
EC36T000
WHEEL INSPECTION
1. Inspect:
9Wheel runout
Elevate the wheel and turn it.
Abnormal runout → Replace.
Standard tire pressure:
100 kPa (1.0 kg/cm
2
, 15 psi)
3 Nm (0.3 m•kg, 2.2 ft•lb)
5MV-9-10-3B 6/12/00 8:22 PM Page 15