Filter
Top Products
4-36
ENG
CLUTCH AND PRIMARY DRIVEN GEAR
EC495121
Push lever
1. Install:
9Torsion spring 1
9Push lever 2
To push lever axle 3.
NOTE:
9Install the push lever with its
5
mark a down-
ward.
9Temporarily install the torsion spring and push
lever at this point.
2. Check:
9Push lever position
NOTE:
When pushing the push lever forward, the front
line b should be within the range a. If not, rein-
stall the push lever.
3. Adjust:
9Push lever position
10. Install:
9Clutch cover 1
9Bolt (clutch cover) 2
NOTE:
Tighten the bolts in stage, using a crisscross
pattern.
10 Nm (1.0 m•kg, 7.2 ft•lb)
Adjustment steps:
9Remove the push lever 1 from the push
lever axle 2.
9Re-install the push lever so that the projec-
tion is positioned between alignment marks
when pushing the push lever forward.
9. Install:
9Gasket (clutch cover) 1
NOTE:
Position the rack a on the push rod backward.
5MV-9-10-4B 6/12/00 8:40 PM Page 17