Filter
Top Products
5-43
CHAS
HANDLEBAR
2. Install:
9Grip cap (upper) 1
9Grip cap (lower) 2
9Bolt (grip cap) 3
NOTE:
Temporarily tighten the bolts (grip cap).
EC5B5210
Handlebar
1. Install:
9Handlebar 1
9Handlebar holder 2
9Bolt (handlebar holder) 3
NOTE:
9
The upper handlebar holder should be installed
with the punched mark a forward.
9
First tighten the bolts on the front side of the
handlebar holder, and then tighten the bolts on
the rear side.
2. Install:
9Grip (left) 1
Apply the adhesive to the handlebar 2.
NOTE:
9Before applying the adhesive, wipe off grease
or oil on the handlebar surface a with a lac-
quer thinner.
9Install the grip (left) to the handlebar so that the
line b between the two arrow marks faces
straight upward.
3. Install:
9Collar 1
9Cap cover 2
9Throttle 3
NOTE:
9Apply the lithium soap base grease on the
throttle grip sliding surface.
9Tighten the grip cap bolts temporarily without the
throttle being fixed to the handlebar.
28 Nm (2.8 m•kg, 20 ft•lb)
5MV-9-10-5B 6/13/00 3:17 PM Page 5-43