Filter
Top Products
3-19
REAR BRAKE ADJUSTMENT/
FRONT BRAKE PAD INSPECTION AND REPLACEMENT
INSP
ADJ
EC365080
FRONT BRAKE PAD INSPECTION AND
REPLACEMENT
1. Inspect:
9
Brake pad thickness a
Out of specification → Replace as a set.
2. Replace:
9
Brake pad
Brake pad thickness
aa
:
Standard
4.4 mm (0.17 in)
<Limit>
1.0 mm (0.04 in)
Brake pad replacement steps:
9
Remove the pad pin plug 1.
EC364002
REAR BRAKE ADJUSTMENT
1. Check:
9
Brake pedal height a
Out of specification→Adjust.
2. Adjust:
9
Brake pedal height
Brake pedal height
aa
:
5 mm (0.20 in)
Pedal height adjustment steps:
9
Loosen the locknut 1.
9
Turn the adjusting nut 2 until the pedal
height a is within specified height.
9
Tighten the locknut.
w
9
Adjust the pedal height between the
maximum
ÅÅ
and the minimum
ıı
as
shown. (In this adjustment the bolt
33
end
bb
should protrude out of the lower
adjusting nut
44
but not be less than 2
mm (0.08 in)
cc
away from the brake ped-
al
55
).
9
After the pedal height adjustment, make
sure that the rear brake does not drag.
5MV-9-10-3A 6/12/00 8:26 PM Page 20