Filter
Top Products
04 Interior
88
Cargo area
04
Hard cargo cover (option)
Fitting the cargo cover
– Retract all four lock plungers by pulling the
lock buttons to their end positions before
lifting in the cargo cover into the cargo
area. The lock plungers stop in retracted
position.
– Lift the cargo cover carefully into the
cargo area sideways, turn it back around
and angle the front edge up slightly.
Locks and support pins
– Locate the front section of the two support
pins behind the active locks (A) on both
sides.
– Align one of the rear locks at (B) and
extend the lock plunger by moving the
lock button forwards.
– Align the other rear lock in the same way
and extend the lock plunger by moving the
lock button forwards.
– Extend the front lock plungers, one at a
time so that they lock in their active
locks (A).
The cargo cover hatch can be raised during
loading.
Removing the cargo cover
– Retract the front lock plungers at (A) to
their end positions by pulling back the lock
buttons on both sides.
– Retract the rear lock plungers at (B) to
their end positions by pulling back the lock
buttons on both sides.
– Lift up and turn the cargo cover before
lifting it from the cargo area.
NOTE
The cargo cover has no load-securing func-
tion Never load anything on top of the cargo
cover. For securing loads, see page 140.