Filter
Top Products
10 Infotainment system
209
Phone functions (option)
10
On/Off
A handset appears in the display when the
phone system is active or in standby mode. If
the ignition key is turned to position 0 when
the phone is in one of these modes, the
phone automatically resumes this mode the
next time the key is turned to position I or II.
Activating the phone system
Phone system functions can only be used
when the phone is in active mode.
–Press PHONE.
– Enter the PIN code (if necessary) and
press ENTER.
Deactivating the phone system
No calls can be received when the phone is
deactivated.
–Hold PHONE depressed until the phone is
activated.
Standby
In standby mode, the audio system can be in
use while calls are received. However, it is
not possible to make calls when in standby
mode.
Putting the phone in standby mode
The phone must first be in active mode be-
fore it can be put in standby mode.
– Press PHONE or EXIT.
Activating from standby mode
– Press PHONE.
Making and receiving calls
If the privacy handset is raised when a phone
call is started, the sound will come from the
handsfree system. For information on switch-
ing between privacy handset and handsfree
during a call, see page 211.
To call
– Activate the phone system (if necessary).
– Dial the number or use the phone book,
see page 211.
– Press ENTER or lift the handset. Release
the handset by pressing it down.
Receiving a call
For Auto answer, see menu option 4.3,
page 213.
– Press ENTER or lift the handset. Release
the handset by pressing it down.
Ending a call
– Press EXIT or hang up the handset.
Refusing a call
– Press EXIT.
Call waiting
A two-tone signal during a phone call indi-
cates that there is another incoming call. An-
swer? appears on the
display. The call can
be refused or taken in the normal manner. If
the incoming call is taken, the previous call is
put on hold.
Putting a call on hold/resuming a call
– Press MENU.
–Scroll to
Hold or Hold off and press
ENTER.
Dialling a third party
– Put the call on hold.
– Dial the number of the third party.
Switching between calls
– Press MENU.
–Scroll to
Swap and press ENTER.
Starting a conference call
A conference call consists of at least three
parties that can talk to one another. Once a
conference call has been initiated, no more
parties can be connected. All calls are ended
when a conference call is ended.
– Start two phone calls
– Press MENU.
–Scroll to
Join and press ENTER.