Filter
Top Products
Unit 4: Printer Configuration
Lt408 Operator Manual
4-38 PN: 9001152A
TEST PRINT MODE (TABLE 4-16)
MENU DESCRIPTION
Is the initial screen of the Test Print Mode.
• Configuration: The printer’s configuration settings.
•Barcode: The printer’s installed barcodes.
• Head Check: A pattern to check print head elements.
• Font: The contents of the installed fonts.
• Factory: A factory test label will be printed.
This screen only appears if Configuration, Barcode, or Head Check was chosen in the
previous menu. The increments of measure are 1cm.
For factory test prints, this screen appears instead of the previous screen for setting
print size.
Large (10cm) and small (4cm) print sizes are the only two options.
Pressing ENTER will indicate continuous test printing. Pressing ENTER again will
suspend printing.
If the external signal is enabled, the test print must be initiated with a print start signal via
the EXT port.
HEX DUMP MODE (TABLE 4-17)
MENU DESCRIPTION
Displays the operational status of the printer. The ONLINE status is displayed on the top
line and the label quantity status on the bottom. The message will be changed to
OFFLINE whenever the printer is switched offline by pressing the LINE key. When a
print job is received, the quantity line will indicate the number of labels to be printed. As
the label job prints, the display indicates the number of labels remaining to be printed.
Displays the operational status of the printer. The OFFLINE status is displayed on the
top line and the label quantity status on the bottom. The message will be changed to
ONLINE whenever the printer is switched online by pressing the LINE key.
Is a transitional screen that allows the operator to choose a given direction within the
menu map.
TEST PRINT MODE
CONFIGURATION
BARCODE
HEAD CHECK
FONT
FACTORY
TEST PRINT SIZE
10 mm
TEST PRINT SIZE
LARGE SMALL
TEST PRINT
PRESS ENTER KEY
ONLINE
QTY: 000000
OFFLINE
QTY: 000000
ONLINE MODE