Filter
Top Products
Unit 4: Printer Configuration
Lt408 Operator Manual
4-22 PN: 9001152A
Allows the choice of continuous feed or dispenser operation.
Allows the determination of whether a backfeed motion will be applied. If so, the
selection of before or after the printing of each label.
Allows the printer to be switched to operate in the thermal transfer or direct thermal
mode as desired.
Allows the pitch sensor to be activated or deactivated as circumstances dictate.
Allows the pitch sensor mode to be selected relative to the media type being used.
This feature determines the integrity of the print head elements when enabled. The
printer will go into error mode when a malfunctioning printhead element is detected.
This screen will appear if the head check feature has been selected. Choose for the
head check to be performed unconditionally or only when barcodes are being printed.
Previously printed barcodes should be scanned following an error to determine their
functionality.
Set this feature to enable or disable the printer’s external signal communication port. If
the port is enabled, data can be sent and received using an appropriate device plugged
into the EXT port.
Appears only if the printer’s external signal feature has been enabled to allow selection
of the output signal. For information on which type to choose, refer to this printer’s
Programming Reference for guidance.
ADVANCED MODE (TABLE 4-2)
MENU DESCRIPTION
PRINTER TYPE
DISPENSER
CONTINUOUS
BACKFEED MOTION
BEFORE
NONE
AFTER
PRINT METHOD
TRANSFER DIRECT
PITCH SENSOR
ENABLE DISABLE
SENSOR TYPE
I-MARK GAP
HEAD CHECK
ENABLE DISABLE
HEAD CHECK
NORMAL BARCODE
EXTERNAL SIGNAL
ENABLE DISABLE
EXTERNAL SIGNAL
TYPE 1 TYPE 2
TYPE 3 TYPE 4