Filter
Top Products
Panorama roof with power tilt/sliding panel (sedan)
198
Such an opening also presents a potential
for injury for occupants wearing their seat
belts properly as entire body parts or
portions of them may protrude from the
passenger compartment.
!
To avoid damaging the seals, do not
transport any objects with sharp edges
which can stick out of the tilt/sliding panel.
Do not open the tilt/sliding panel if there is
snow or ice on the roof, as this could result
in malfunctions.
!
Please keep in mind that weather
conditions can sometimes change rapidly.
Make sure to close the tilt/sliding panel
when leaving the vehicle. If water enters
the vehicle interior, vehicle electronics
could be damaged which is not covered by
the Mercedes-Benz Limited Warranty.
Roof panel switch
1
Opening
2
Closing
3
Raising
4
Lowering
The tilt/sliding panel only operates with the
roller sunblinds retracted.
i
You can also open or close the tilt/sliding
panel using the SmartKey, see “Summer
opening feature” (Y page 122) or see
“Convenience closing
feature” (Y page 123).
X
Switch on the ignition.
Opening
X
Opening manually: Press and hold the
roof panel switch to the resistance point in
direction of arrow 1.
X
Release the roof panel switch when the
desired position is reached.
X
Express operation: To open the tilt/
sliding panel completely, press the roof
panel switch past the resistance point in
direction of arrow 1 and release.
X
Stopping during express operation:
Move the roof panel switch in any direction.
i
When the tilt/sliding panel is open,
resonance noises may result in addition to
the usual wind noises. They are caused by
minimal pressure changes in the passenger
compartment. To reduce or eliminate these
noises, change the position of the tilt/
sliding panel or open a window slightly.
Raising
X
Press and hold the roof panel switch to the
resistance point in direction of arrow 3.
X
Release the roof panel switch when the
desired position is reached.
Controls in detail