Filter
Top Products
Lighting
110
1
Driver’s side exterior rear view mirror
button
2
Passenger side exterior rear view mirror
button
3
Adjustment button
4
Memory button M
X
Stop the vehicle.
X
Switch on the ignition.
X
Press button 2.
The passenger-side exterior rear view
mirror is selected.
X
Adjust the passenger-side exterior rear
view mirror with adjustment button 3 so
that you see the rear wheel and the road
curb.
X
Press memory button M 4.
X
Within 3 seconds, press bottom of
adjustment button 3.
The parking position is stored if the mirror
does not move.
i
If the mirror does move, repeat the above
steps. After the setting is stored, you can
move the mirror again.
Lighting
Notes
i
If you drive in countries where vehicles
drive on the other side of the road than the
country where the vehicle is registered, you
must have the headlamps modified for
symmetrical low beams. Relevant
information can be obtained at any
authorized Mercedes-Benz Center.
i
Vehicles equipped with active Bi-Xenon
headlamps:
The active Bi-Xenon headlamps monitor the
vehicle’s steering angle and speed, then
automatically shift their beams to either
side to better follow the curvature of the
road ahead, increasing usable illumination
over conventional headlamps.
Controls in detail