Filter
Top Products
Lighting
112
traffic and/or ambient lighting conditions
require you to do so.
In low ambient lighting conditions, only
switch from position U to B with the
vehicle at a standstill in a safe location.
Switching from U to B will briefly
switch off the headlamps. Doing so while
driving in low ambient lighting conditions
may result in an accident.
The automatic headlamp feature is only an
aid to the driver. The driver is responsible
for the operation of the vehicle’s lights at
all times.
X
Switching on: Turn the exterior lamp
switch to position U.
With the SmartKey in starter switch
position 1 or the KEYLESS-GO start/stop
button pressed once, the tail and parking
lamps, the license plate lamps and the side
marker lamps will come on and go out
depending on the brightness of the ambient
light.
When the engine is running the low-beam
headlamps, the tail and parking lamps, the
license plate lamps and the side marker
lamps will come on and go out depending
on the brightness of the ambient light.
Canada only: High-beam headlamps are only
available with the exterior lamp switch in
position B.
Daytime running lamp mode
In Canada, the daytime running lamp mode is
mandatory and therefore in a constant mode.
In the USA, the daytime running lamp mode
is deactivated by default. Activate the
daytime running lamp mode using the control
system, see “Setting daytime running lamp
mode (USA only)” (Y page 153).
X
Turn the exterior lamp switch to position
M or U.
When the engine is running, the low-beam
headlamps come on.
In low ambient lighting conditions, the
following lamps will come on additionally:
R
Tail lamps
R
Parking lamps
R
License plate lamps
R
Side marker lamps
With the daytime running lamp mode
activated and the engine running, you cannot
switch off the low-beam headlamps manually.
Canada only
With the exterior lamp switch in position
M or U, you cannot switch on the high-
beam headlamps.
The high-beam flasher is available at all times.
For nighttime driving turn the exterior lamp
switch to position B to permit activation
of the high-beam headlamps.
When the engine is running, and you
R
shift from a driving position to park position
P with the vehicle at a standstill, the low-
beam headlamps will go out with a delay of
3 minutes
R
turn the exterior lamp switch to position
C, the low-beam headlamps, the tail
and parking lamps, the license plate lamps
and the side marker lamps come on
R
turn the exterior lamp switch to position
B, the manual headlamp mode has
priority over the daytime running lamp
mode
The corresponding exterior lamps come on
(Y page 111).
USA only
You can only switch on the high-beam
headlamps in low ambient lighting conditions.
The high-beam flasher is available at all times.
Controls in detail