Mercedes-Benz 2009 E-Class Automobile User Manual


 
Climate control system
192
Air recirculation mode
Switch to air recirculation mode to prevent
unpleasant odors from entering the vehicle
from the outside (e. g. before driving through
a tunnel). This setting cuts off the intake of
outside air and recirculates the air in the
passenger compartment.
G
Warning!
Fogged windows impair visibility,
endangering you and others. If the windows
begin to fog on the inside, switching off the
air recirculation mode immediately should
clear interior window fogging. If interior
window fogging persists, make sure the air
conditioning is activated, or press button
y.
X
Activating: Press button ,.
The indicator lamp in the button comes on.
i
The air recirculation mode is activated
automatically at high outside temperatures
and if the concentration of carbon
monoxide (CO) and nitrogen oxide in the
outside air increases, for example in a
tunnel.
The indicator lamp in button , is not lit
when the air recirculation mode is switched
on automatically.
A quantity of outside air is added after
approximately 30 minutes.
X
Deactivating: Press button , again.
The indicator lamp in the button goes out.
i
The manually selected air recirculation
mode is deactivated automatically:
R
after 5 minutes if the outside
temperature is below approximately
41‡ (5†)
R
after 5 minutes if the air conditioning is
turned off
R
after 30 minutes if the outside
temperature is above approximately
41‡ (5†)
Residual heat and ventilation
This feature is only available in Canada
vehicles. With the engine switched off, it is
possible to continue to heat or ventilate the
interior for up to 30 minutes. This feature
makes use of the residual heat produced by
the engine.
i
If you switch on the residual heat function
when outside temperatures are high, only
the ventilation will be switched on.
i
Regardless of the selected air volume, the
blower operates at low speed.
i
How long the system will provide heating
depends on the coolant temperature and
the selected temperature. The blower will
run at speed setting 1 regardless of the air
volume control setting.
X
Activating: Switch off the ignition.
X
Press button T.
The indicator lamp in the button comes on.
X
Deactivating: Press button T.
The indicator lamp in the button goes out.
Controls in detail