Filter
Top Products
101
Update Trail Criteria
There are three criteria by which trails may be updated: automatic,
time or distance. When it is in the default automatic mode, the unit
does not update the plot trail while you are traveling in a straight line.
Once you deviate from a straight line, the unit drops a plot point (trail
waypoint) onto the trail. This conserves plot trail points. If a plot trail
uses all of the available points allotted to it, the beginning points are
taken away and placed at the end of the trail.
Update Criteria with Time selected (left). With the setting above, the
trail would update every three seconds. Distance is selected (right). It
is set to update the trail every .10 of a mile.
Trail Update Rate
You can update a trail by time, with a range from 1 to 9999 seconds.
The default is 3 seconds. You can update by distance, with a range from
0.01 mile/nm/km to 9.99 mile/nm/km. The default is 0.10 mile.
Highlight either
TIME or DISTANCE from the Update Criteria menu and
press
ENT. That will launch a data entry box. Press ↓ to the data entry
box and press
ENT. Use the ↑ ↓ keys to change the first character, then
press → to the next character and repeat until the entry is correct.
Press
EXIT|EXIT to return to the Trails Menu.
Specific Trail Options
Delete Trail
To delete a specific trail from the Trails menu, press ↓ to the list of
saved trails, select a trail and press
ENT. The Edit Trail menu appears
as seen in the following figure. Press ↓ to
DELETE TRAIL|ENT|← to
YES|ENT.
New Trail
If you want to manually start a new trail from the Trails Menu, high-
light NEW TRAIL and press ENT. The edit trail menu appears with the
new trail name listed in the name box at the top.