Filter
Top Products
9.10
Section 9
Disassembly
Figure 9-36. Lower Hose Removed.
6. Lift the entire cooling system, with the radiators,
hoses, and supporting brackets attached, off the
engine. See Figure 9-37. Further disassembly
may be performed as required. When
disassembly of hose connections is necessary,
the use of a rubber lubricant on the inside of
hoses will make installation easier.
Figure 9-37. Lifting the Cooling System Off.
Figure 9-39. Removing Rectifier-Regulator.
3. Unplug the connector from the rectifier-regulator.
Using a small screwdriver or other narrow flat
blade, bend down the locking tang on the center
terminal and pull the B+ charging lead out of the
connector. See Figure 9-40.
Figure 9-38. Removing Stator.
2. Remove the single screw securing the ground
lead and rectifier-regulator. Lift the rectifier-
regulator off the locating post. Work the stator
leads out from under the retaining tab in the lower
housing. See Figure 9-39.
Remove Stator and Rectifier-Regulator
1. Remove the two stator mounting screws. See
Figure 9-38.