Filter
Top Products
2.1
Section 2
Special Tools
2
LV560, LV625, LV675
Section 2
Special Tools
These quality tools are designed to help you perform specific disassembly, repair, and reassembly procedures.
By using tools designed for the job, you can service engines easier, faster, and safer! In addition, you’ll increase
your service capabilities and customer satisfaction by decreasing engine downtime.
Camshaft End play Plate ................................................................................. KO1031*
Flywheel Puller Kit ........................................................................................... NU3226*
Hose Clamp Pliers ........................................................................................... KO1043*
Valve Guide Reamer........................................................................................ KO1026*
Hydraulic Lifter Removal Tool .......................................................................... KO1044*
Rocker Arm Spanner Wrench .......................................................................... (Obtain locally)
Water Manometer ............................................................................................ 25 761 02-S
Vacuum Gauge................................................................................................ 25 761 22-S
Cylinder Leakdown Tester................................................................................ 25 761 05-S
Ignition System Tester ..................................................................................... 24 455 02-S
Starter Ring Tool .............................................................................................. 25 761 18-S
*These items can be ordered through your Kohler distributor or purchased directly from SPX
Corp. by phoning 1-800-533-0492.
Ignition System Tester
Use Kohler Part No. 24 455 02-S to test the CD
ignition modules on the AEGIS
™
engines.
Cylinder Leakdown Tester
Kohler Part No. 25 761 05-S Cylinder Leakdown Tester
is a valuable alternative to a compression test. By
pressurizing the combustion chamber from an external
air source, this tool can determine if valves or rings are
leaking. Instructions for using this tester are found on
pages 3.3 and 3.4 of this manual.
Figure 2-1. Hose Clamp Pliers.
Go Back