Kenwood DNX9210BT GPS Receiver User Manual


  Open as PDF
of 58
 
8484 85
Return to the Top page
Audio Setting Up
Return to the Top page
Audio Setting Up
Car type setup
Youcansetupthecartypeandspeaker
network,etc.
1
Touch [Car Type] in the Audio SETUP
screen.
Car Type screen appears.
2
Select your car type from the list.
NOTE
•Ifyourcartypeisselected,theDelayTime
Alignmentissetautomatically(fortiming
adjustmentofsoundoutputforeachchannel)to
havethehighestsurroundeffects.
Speaker location setup
1
In the Car Type screen, touch
[Location].
Speaker Location screen appears.
2
Select the speaker locations using
[3].
Front Speaker
Selectthelocationfrom“Door”/“OnDash”/
“UnderDash”.
Rear Speaker
Selectthelocationfrom“Door”/“RearDeck”,
“2ndRow”/“3rdRow”(Minivan,PassengerVan).
DSP select
YoucanselectwhetherusingDSP(Digital
SignalProcessor)System.
1
Touch [Bypass] or [Through] of [DSP
Select] in the Audio SETUP screen.
Bypass
ThereisnoeffectbyDSP.
Through
ThereisaneffectbyDSP.
NOTE
•Whenthemodeissetto[Bypass],DSPSystem
cannotbeadjusted.
Controlling General Audio
1
Touch [Audio Control].
2
Set each item as follows.
Fader #/Balance #
Adjustthevolumebalancearoundthe
touchedarea.
[2]and[3]adjusttherightandleftvolume
balance.
[5]and[∞]adjustthefrontandrearvolume
balance.
Volume Offset*
Finelyadjustthevolumeofthecurrentsource
tominimizethedifferenceinvolumebetween
differentsources.
Subwoofer Level
Adjuststhesubwoofervolume.Thissettingis
notavailablewhensubwooferissetto“None”.
SeeSpeaker setup (P.82).
Bass Boost
Setstheamountofbassboostamong“OFF”/
“Level1”/“Level2”/“Level3”.
*Ifyouhaveincreasedthevolumefirst,then
reducedthevolumeusingthe“Volume
Offset”,thesoundgeneratedifyou
suddenlyswitchtoanothersourcemaybe
extremelyloud.
 previous next