Kenwood DNX9210BT GPS Receiver User Manual


  Open as PDF
of 58
 
8282 83
Return to the Top page
Audio Setting Up
Return to the Top page
Audio Setting Up
NOTE
•Eachoperationinthissectioncanbestartedfrom
themultifunctionmenu.
Youcanadjustthevarioussettingssuchas
audiobalanceorsubwooferlevel.
1
Touch [Menu] on any screen.
2
Touch [Audio].
Audio screen appears.
See the following section for each setting.
• Setting audio (P.82)
• Controlling audio (P.85)
• Controlling equalizer (P.86)
• Controlling soundeffect(P.87)
• Performing zone control (P.89)
• Set listening position (P.90)
Setting Audio
1
Touch [Audio SETUP].
Audio SETUP screen appears.
See the following section for each setting.
• Set up speakers (P.82)
• Set up your car type (P.84)
• Select DSP
(P.85)
Speaker setup
Youcanselectaspeakertypeanditssizeto
getthebestsoundeffects.
Whenthespeakertypeandsizeareset,
thespeakercrossovernetworkisset
automatically.
1
Touch [Speaker Select] in the Audio
SETUP screen.
Speaker Select screen appears.
2
Touch the speaker you wish to adjust
and set each item as follows.
Controlling Audio
Tweeter
Youcansetthetweeterwhenyouare
selectingfrontspeakers.
None,Small,Middle,Large
X’over
Displaysthespeakercrossoversetupscreen.
Youcanadjustthecrossoversetupthatwasset
automaticallywhenyouselectedthespeaker
type.
Fordetails,seeCrossover network setup
(P.83)
3
Select a speaker size using [2] and
[3]. The speaker size is different
depending on the speaker type and
the unit.
Front
OEM,8cm,10cm,12cm,13cm,16cm,17cm,
18cm,4x6,5x7,6x8,6x9,7x10
Rear
None,OEM,8cm,10cm,12cm,13cm,16cm,
17cm,18cm,4x6,5x7,6x8,6x9,7x10
Subwoofer
None,16cm,20cm,25cm,30cm,38cmover
NOTE
•Select“None”ifyouhavenospeakers.
Crossover network setup
Youcansetacrossoverfrequencyof
speakers.
1
Touch the speaker to set the crossover
in the Speaker Select screen.
2
Touch [X’over].
X’over screen appears.
3
Set each item as follows.
TW (Tweeter) Gain *
1
Adjuststhetweeterlevel.(Whenfrontis
selectedonSpeakerSelectscreen)
Gain
Adjuststhefrontspeaker,rearspeaker,or
subwooferlevel.
Phase *
2
Setsthephaseofsubwooferoutput.
Thephaseisreversed180degreeswhenset
to“Reverse”.(Whensubwooferisselectedon
SpeakerSelectscreen)
HPF FREQ
HighPassFilteradjustment.(Whenfrontorrear
speakerisselectedonSpeakerSelectscreen)
LPF FREQ
LowPassFilteradjustment.(Whensubwoofer
isselectedonSpeakerSelectscreen)
Slope
*
3
Setsacrossoverslope.
*
1
Onlywhen“Tweeter”issetto“Small”,
“Middle”,“Large”in<SpeakerSetup>.
*
2
Onlywhen“Subwoofer”issettoamode
otherthan“None”in<SpeakerSetup>.
*
3
Onlywhen“LPFFREQ”/“HPFFREQ”issetto
amodeotherthan“Through”in<X’over>.
 previous next