Kenwood DNX9210BT GPS Receiver User Manual


  Open as PDF
of 58
 
7272 73
Return to the Top page
Setting Up
Return to the Top page
Setting Up
Security setup
operation
Youcansetupasecuritycodetoprotect
yourreceiversystemagainsttheft.
NOTE
•WhentheSecurityCodefunctionisactivated,the
codecannotbechangedandthefunctioncannot
bereleased.NotetheSecurityCodecanbesetas
the4digitnumberofyourchoice.
1
Touch [Security] in the System Menu
screen.
Security screen appears.
2
Touch [ON] of [SI].
NOTE
•If“SI”isturnedon,theSIindicatoronthesub
panelflasheswhenthevehicleignitionisoffand
thepanelisdetached.Defaultis“ON”.
3
Touch [SET] of [Security Code Set].
NOTE
•Ifyouhavealreadycompletedthecode
registration,[CLR]isdisplayed.
4
Enter a security code with four-digit
number and touch [Enter].
5
Enter the same code again and touch
[Enter].
Security code is registered.
NOTE
•Ifyouenteradifferentsecuritycode,thescreen
returnstostep4(forthefirstcodeentry).
•Ifyouhavepressed<Reset>buttonorifyou
havedisconnectedtheReceiverfrombattery,
enterthecorrectsecuritycodeasthatyouhave
enteredinstep4andtouch[Enter].Youcanuse
yourReceiver.
EXT SW setup
Setuptheexternalswitchpowermode.
1
Touch [EXT SW] in the System Menu
screen.
EXT SW screen appears.
2
Set each item as follows.
SW Name
Setsthenameoftheexternaldevice.
Output Pattern
Setsthepowersignaloutputmodeamong
“Pulse”/“Level”.Defaultis“Pulse”.
Youcansettoturnoutputon/offeachtime
thebuttonontheEXTSWscreenistouched.
SeeExternal Device Control (P.80).
Pulse Set
Setsthepulsesignaloutputtime.
Outputs500mswhen“1”isset.
Increasesby200mswitheachstep.Upto100
stepscanbeset.
NOTE
•Youcanentercharactersonlyafteryouhave
appliedtheparkingbrake.
•“Pulse”:Generatesasinglepowersignalpulse.
•“Level”:Continuesoutputofhighpowersignal.
Setup memory
AudioControl,AV-INSETUP,Camera,and
AudioSETUPsettingscanbememorized.The
memorizedsettingscanberecalledatany
time.Forexample,evenwhenthesettings
areclearedduetoreplacementofthe
battery,thesettingscanberestored.
1
Touch [SETUP Memory] in the System
Menu screen.
SETUP Memory screen appears.
2
Follow the instruction on the screen.
[Lock]/[Unlock]*
LocksorunlockstheAV-INSETUP,andAudio
SETUPsettings.
Yes
Memorizesorrecallsthesettings.
No
Cancelsthefunctionormemorization.
TheSETUPMenuscreenappearsagain.
*When[Lock]isselected,youcannotchange
theAV-INSETUP,andAudioSETUPsettings.
Also,thelockedkeymarkisdisplayed
undereachsettingiconinthesetupmenu.
Continued
 previous next