Filter
Top Products
CONTROL MODULE PIN OUT INFORMATION
BODY PROCESSOR MODULE
Description
Active
IGNITION SWITCHEO GROUND SUPPLY
IGNITION SWiTCHED GROUND SUPPLY
IGNITION SWITCHED GROUND SUPPLY
BATTERY POWER SUPPLY (LOGIC)
AUDIBLE WARNING SPEAKER OUTPUT
AUDIBLE WARNING SPE*KER OUTPUT
SCP NEWORK
SC? NETWORK
B*nERY POWER SUPPLY
GROUND
GROUND
GROUND
B+
*UDIO OUTPUT
BUD,0 OUTPUT
2- ,600 Hz
2 - ,600 Hi
67
Inactive
GROUND
B*
NOTE: REFER TO THE APPENDIX AT THE REAR OF THIS BOOK FOR CAN AND SCP NETWORK MESSAGES.
The following symbols are used to represent values for Control Module Pin Out data:
I
Input
0 output
SG Signal Ground
D Serial and encoded communications
C CAN (Network)
S SCP Network
B+ Battery voltage
V Voltage (DC)
Hz Frequency
KHz Frequency x 1000
MS Milliseconds
MV Millivolts
CAUTION: The information on this data page is furnished to aid the user in understanding circuit operation. THIS INFORMATION SHOULD BE USED FOR
REFERENCE ONLY.
COMPONENTS
Component
Connector I Type I Color
Location I Access
AVDIBLE WARNING SPEAKER (COLUMN SWITCHGE*Rl
SC,, 12.WAY MULTILOCK 070,VMTE
STEERING COLUMN, RIGHT HAND SIDE
BODY PROCESSOR MODULE
FC141704~WAY AMP EEEC; GREY
PASSENGER SIDE FASCIA: *IRBAG BRACKEl
CONTROL MODULE PIN OUT INFORMATION (FOLD OUT PAGE)
+
NOTE: The values listed are approximately those that can be
expected
at the control module connector
pins
with all circuit connections made and all
COmPOnentS
connected and fitted. “Active” means a load is
applied or a switch is ON; “Inactive” means a load is not applied or a switch is
OFF.
REFER TO THE FRONT OF THE BOOK FOR ILLUSTRATIONS DETAILING THE LOCATION AND IDENTIFICATION OF COMPONENTS, RELAYS.
CONNECTORS, HARNESSES, GROUNDS, VEHICLE CONTROL MODULES AND CONTROL MODULE PINS.
DATE OF ISSUE: FEBRUARY 1998