Filter
Top Products
CONTROL MODULE PIN OUT INFORMATION
ABS /TRACTION CONTROL CONTROL MODULE
\I Pin
Description
0 LF37-1
BRAKE FLUID RESERVOIR LEVEL SWITCH REFERENCE
LKw2
BRAKE SWlTCH
LF37-3
RH FRONT WHEEL SPEED SENSOR
SG
LF37-4
RH FRONT WHEEL SPEED SENSOR
c LF37~5
CAN NETWORK
SG
LF37~6
RH REAR WHEEL SPEED SENSOR
I LF37-7
RH REAR WHEEL SPEED SENSOR
LF37-8
GROUND
LF37 9
EATERY POWER SUPPLY
LF37-10
NOT USED
LF37-l,
NOT “SE0
/ LF37-13
BRAKE FLUID RESERVOIR LEVEL SWiTCH
STABILITY, TRACTION CONTROL SWATCH
CAN NETWORK
STABILITY I TRACTION CONTROL SWlTCH STATE LEO
LH FRONT WHEEL SPEED SENSOR
LH FRONT WHEEL SPEED SENSOR
NOT USED
BATTERY POWER SUPPLY
NOTE: REFER TO THE APPENDIX AT THE REAR OF THIS BOOK FOR CAN AND SCP NETWORK MESSAGES.
Inactive
E+
B+
GROUtiD
B-
E+
B+
Ei
GROUND
GROUND
ES+
COMPONENTS
Component
Connector / Type / Color
Location / Access
AES /TRACTION CONTROL CONTROL MODULE
LF37 i E-WAY AMP HYBRID, BLACK ENGINE COMPARTMENT, FRONT LEFT
BRAKE FLUID RESERVOlR
EM37 / Z-WAY AMP JUNIOR POWER TIMER, BLACK
ENGINE COMPARTMENT, BRAKE BOOSTER ENCLOSURE
BRAKE SWTCH
AC24, I-WAY MULTILOCK 070 I WHITE
TOP OF BRAKE PEDAL
HARNESS-TO-HARNESS CONNECTORS
Location / Access
FASClA
BOTTOM CONNECTOR
MOUNTING
BRACKET, RIGHT
HAND SIOE
TRUNK, ABOVE RIGHT HAND REAR WHEEL ARCH
REAR OF REAR HUB ASSEMBLY, LEFT HAND SlDE
REAR OF REAR HUB ASSEMBLY, RIGHT HAND SIDE
ENGINE COMPARTMENT, LEFT HAND ENCLOSURE
ENGINE COMPARTMENT,ADJACENTTO ENGINE COMPARTMENT FUSE BOX
ENGINE COMPARTMENTiADJACENTTOAlR CLEANER
LEFT HAND ‘K POST CONNECTOR MOUNTlNG BRACKET, ‘4’ POST TRIM
BEHIND GLOVE BOX
GROUNDS
Ground
FClER
FC4BR
LFSAS
Location / Type
EYELET PAIR, - RIGHT HAND LEG, RIGHT HAND ‘K POST
EYELET ,PAlR, -
RIGHT
HAND
LEG,
LEFT HAND ‘N POST
EYELET ISINGW,ENGINE COMPARTMENT, FORWARD OF LEFT HAND HOOD CATCH
CONTROL MODULE PIN OUT INFORMATION (FOLD OUT PAGE)
+
The following symbols are used to represent values for Control Module Pin Out data:
I
Input
D Serial and encoded communications
0 output
B+ Battery voltage
KHz Frequency x 1000
C CAN (Network)
MS Milliseconds
SG Signal Ground
V Voltage (DC)
S
SCP Network
Hz Frequency MV Millivolts
CAUTION: The information on this data page is furnished to aid the user in understanding circuit operation. THIS INFORMATION SHOULD BE USED FOR
REFERENCE ONLY.
NOTE: The values listed are approximately those that can be expected at the control module connector pins with all circuit connections made and all
COmPOnentS
connected and fitted. “Active” means a load is applied or a switch is ON; “Inactive” means a load is not applied or a switch is OFF.
REFER TO THE FRONT OF THE BOOK FOR ILLUSTRATIONS DETAILING THE LOCATION AND lDENTlFlCATlON OF COMPONENTS. RELAYS,
CONNECTORS, HARNESSES, GROUNDS, VEHICLE CONTROL MODULES AND CONTROL MODULE PINS.
DATE OF ISSUE: FEBRUARY 1998