Jaguar XK8 Automobile User Manual


 
CONTROL MODULE PIN OUT INFORMATION
ADAPTIVE DAMPING CONTROL MODULE
7 Pin
Description
0
BT69-1
MAJOR INSTRUMENT PACK ADAPTl”E DAMPiNG MI1
0
BT69-3
ACCELEROMETER COMMON GROUND SUPPLY
D
3T69-10
SERIAL COMMUNlcATlONS
I BT69~11
IGNITION SWITCHED POWER SUPPLY
0
BTS9-13
LH REAR DAMPER BA1TERY POWER SUPPLY
0
8769-14
RH FRONT DAMPER BA”ERY POWER SUPPLY
0
mm1 5
RH REAR DAMPER BA”ERY POWER SUPPLY
I BTW23
GRCJUND
I BTW20
FRONT LATERAL ACCELEROMETER FEEDBACK
BT69-21
FRONT VERTICAL ACCELEROMETER FEEDBACK
BT69-22
REAR VERTICAL ACCELEROMETER FEEDBACK
I 3-m-24
VEHICLE SPEED SIGNAL
0
BT.53~25
ACCELEROMETER COMMON VOLTAGE SUPPLY
I BT69-26
BRAKE SWlTCH
3x9-27
BATTERY POWER SUPPLY
D
BT69 28
SERIAL COMM”NlCATlONS
0
8T69-30
LH FRONT DAMPER BAmERY POWER SUPPLY
0
BTW31
LH FRONT DAMPER
0
BTW32
LH REAR DAMPER
0
BT69-33
RH FRONT DAMPER
0
BTW34
RH REAR DAMPER
Active
GROUND
GROUND
B+
GROUND
GROUND
GROUND
GROUND
Inactive
B+
GROUND
GROUND
Bi
.BT
BT
GROUND
23%27”=HARD
2.3 - 2.7 = HARD
2.3 2.7 = HARD
COMPONENTS
Component
ACCELEROMETER-FRONT LA\TERAL
ACCELEROMETER-REAR VERTICAL
ACCELEROMETER-FRONT VERTICAL
ADAPTIVE DAMPING CONTROL MODULE
BRAKE SWITCH
DAMPER SOLENOID - LH FRONT
DAMPER SOLENOID- LH REAR
DAMPER SOLENOlD - RH FRONT
DAMPER SOLENOID RH REAR
Connector / Type I Color
Location / Access
ENGINECOMPARTMENT,AD~ACE~~TO ECM
TRUNK, BELOW FUEL TANK
CENTER CONSOLE, BEHIND ICE HEAD UNIT
TRUNKiADJACENTTO ELECTRlCALCARRlER
TOP OF BRAKE PEDAL
TOP OF LEFT HAND FRONT DAMPER
TOP OF LEFT HAND REAR DAMPER
TOP OF RIGHT HAND FRONT DAMPER
TOP OF RIGHT HAND REAR DAMPER
HARNESS-TO-HARNESS CONNECTORS
Connector Type / Color
Location / Access
FASCIA BOTTOM CONNECTOR MOUNTING BRACKET, RIGHT HAND SlDE
TRUNK/ABOVE RIGHT HAND REAR WHEEL ARCH
TRUNK, ABOVE RIGHT HAND REAR WHEEL ARCH
TR”NK,SELOWFUELTANK
TRUNK, BELOW FUEL TANK
ENGINE COMPARTMENT,ADJACENTTO RIGHT HAND ENCLOSURE
LEFT HAND ‘N POST CONNECTOR MOVNTING BRACKET, ‘A’ POST TRIM
LEFT HAND ‘A’ POST CONNECTOR MOUNTING BRACKET, ‘A’ POSTTRlM
BEHIND GLOVE BOX
REAR OF CENTER CONSOLE ASSEMBLY
REAR OF REAR HUB ASSEMBLY, LEFT HAND SIDE
REAR OF REAR HUB ASSEMBLY, RIGHT HAND SIDE
GROUNDS
Ground
BT23L
Location / Type
EYELET IPAIR) LEFT HAND LEG /TRUNK, RIGHT REAR
CONTROL MODULE PIN OUT INFORMATION (FOLD OUT PAGE)
The following symbols are used to represent values for Control Module Pin Out data:
I
Input
D
Serial and encoded communications
0 output
C CAN (Network)
B+ Battery voltage
SG Signal Ground
V Voltage (DC)
S
SCP Network
Hz Frequency
KHz Frequency x 1000
MS Milliseconds
MV Millivolts
CAUTION: The information on this data page is furnished to aid the user in understanding circuit operation. THIS INFORMATION SHOULD BE USED FOR
REFERENCE ONLY.
NOTE: The values listed are approximately those that can be expected at the control module connector pins with all circuit connections made and all
components
connected and fitted. “Active” means a load is applied or a switch is ON; “Inactive” means a load is not applied or a switch is OFF.
REFER TO THE FRONT OF THE BOOK FOR ILLUSTRATIONS DETAILING THE LOCATION AND IDENTIFICATION OF COMPONENTS, RELAYS,
CONNECTORS, HARNESSES, GROUNDS, VEHICLE CONTROL MODULES AND CONTROL MODULE PINS.
DATE OF ISSUE: FEBRUARY 1998