Filter
Top Products
51
eTrex Vista C
GPS Navigation
Using Routes
List of Turns for an Active Route
using the “Follow Roads” option
Preview of Turn 4 of 9 Turns on a
Route
Navigating a Route
After you have created a route, you can begin navigation immediately.
When you are navigating a route, a guidance message and graphic
view of turns in the route displays as you approach each one. Using the
“Follow Roads” option from the Routing Setup Page increases the number
of turns and displays an Active Route page with a list of turns.
If you
selected the “Off Road” option you can view only the list of points for a route
from the Active Route Page.
(See Routing Setup on page 61.)
To preview the turns for an Active Route:
1. From the Routes Page, highlight the route from the Routes list
and press ENTER to display the Route Page for the route.
2. Highlight the “Navigate” button and press ENTER to begin
navigation and display the route on the Map Page.
3. To view the list of turns on the route, press the QUIT key to
display the Active Route Page. The view any individual turn on
the list, use the ROCKER key to highlight it and press ENTER.
4. The page displays the turn and guidance text and a small fi eld
at the bottom showing the turn number in sequence and total
turns in the route. To scroll through all turn previews, use the
ROCKER key Up and Down arrows. To exit the preview page,
press the QUIT key.
5. To stop navigating, select “Stop Navigation” from the Map or
Compass Page and press ENTER.
This fi eld
changes to red
at the second
warning beep,
when you are
about to reach
the turning
point.
eTrex Vista C Owner's Manual Text.indd 51 8/12/2004, 9:17:22 AM