Filter
Top Products
7. OTHER FUNCTIONS
36
d) Use the cursor pad to enter the
transmission frequency of the DGPS
beacon station to be used and then
press the [ENT] key.
LIST
a) The following display appears after
pressing the [ENT] key at step 6.
STATION (NEAREST)
"*" denotes
user channel.
[EXIT] [USER]
310.0 29.1 nm 92°
287.0 56.7 nm 134°
292.0 160 nm 320°
321.0 234 nm 134°
302.0 426 nm 121° *
Tx frequency of
beacon station
Range (ref. only) and bearing from
ship to beacon station
DGPS beacon station list
b) Use the cursor pad to choose station
desired.
c) Press the [ENT] key.
8. Press the [MENU] key twice to finish.
Programming DGPS user channels
(stations)
The user may program 20 DGPS beacon
stations from which to use in DGPS beacon
station selection. Whenever a new station is
constructed you can add it to the list.
1. Press the [MENU] key twice to open the
menu.
2. Choose DGPS/WAAS and then press the
[ENT] key.
3. Choose DGPS STATION and then press
the [ENT] key.
4. Choose LIST and then press the [ENT]
key.
5. Choose USER and then press the [ENT]
key.
STATION (USER)
[EXIT] [NEW?] [CLR?]
01
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
02
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
03
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
04
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
06
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
DGPS STATION (USER) list
6. Choose “NEW?” and then press the [ENT]
key.
STATION (USER)
NEW USER CHANNEL
FREQ : 310.0kHz
RATE : 200BPS
LAT : 37°59'N
LON : 123°00'W
EXIT? SAVE?
NEW USER CHANNEL (DGPS) set up menu
7. Press the [ENT] key, enter frequency of
the station, and then press the [ENT] key.
8. Press the [ENT] key, enter baud rate of
the station, and then press the [ENT] key.
9. Press the [ENT] key, enter latitude of the
station, and then press the [ENT] key.
10 Press the [ENT] key, enter longitude of
the station, and then press the [ENT] key.
11. Choose “SAVE?” and then press the
[ENT] key.
12. Press the [MENU] key twice to finish.
Editing DGPS user channels
1. Press the [MENU] key twice to open the
menu.
2. Choose WAAS/DGPS and then press the
[ENT] key.
3. Choose DGPS STATION and then press
the [ENT] key.
4. Choose LIST and then press the [ENT]
key.
5. Choose USER and then press the [ENT]
key.