Filter
Top Products
9
2. PLOTTER DISPLAY OVERVIEW
2.1 Choosing the Display
Range
You may choose the display range on the
plotter and highway displays. The horizontal
range in the plotter display is available among
0.02 (40 yd), 0.05 (101 yd), 0.1 (202 yd), 0.2
(405 yd), 0.5, 1, 2, 5, 10, 20, 40, 80, 160 and
320 nautical miles. (Nautical mile is the
default unit of display range. Display range
may also be shown in kilometers or miles.
Ranges shorter than the 0.5 nm are also
shown in yards or meters on the plotter
display.) The horizontal range in the highway
display is available among 0.2, 0.4, 0.8, 1, 2,
4, 8 and 16 nautical miles.
1. Press the [MENU] key. The zoom, ship
centering window appears.
ZOOM IN/OUT?
SHIP TO CENTER?
PRESS [MENU] TO SEE
THE MAIN MENU.
Quit?
Zoom, ship centering window
Note: “SHIP TO CENTER?” does not
appear when the highway display mode is
active.
2. ZOOM IN/OUT is selected. Press the
[ENT] key to show the zoom window.
IN
OUT
▲
▼
20
EXIT:
[ENT]
n
m
ZOOM
Zoom window
3. Use ▲ (increase) or ▼ (decrease) to
choose range desired.
4. Press the [ENT] key to close the zoom,
ship centering window.
2.2 Shifting the Cursor
Use the cursor pad to shift the cursor. The
cursor moves in the direction of the arrow or
diagonal pressed on the cursor pad.
Cursor state and data
Cursor state determines what data is shown
on the display.
Cursor turned on
Cursor position is displayed in latitude and
longitude or TDs (depending on menu
setting) at the bottom of the plotter display
when the cursor is on. The range and bearing
from own ship to the cursor appear at the
left-hand side of the display.
D2D
[ .02
]
n
m
BRG: +
131°
RNG: +
0.03
n
m
+ 34°44.000N 135°21.000E
Bearing from own
ship to cursor
Cursor position in
latitude and longitude
Cursor mark
Cursor
Range from own ship to cursor
Own ship
40 y
d
Plotter display, cursor turned on