Filter
Top Products
4. ROUTES
23
8. Press the [MENU] key twice to finish.
The current position is saved under the
next sequential waypoint number, the
display shows “***SAVED!” (*** =
waypoint number) and a beep sounds.
Thereafter waypoints are saved at the
interval of time or distance set.
When 30 waypoints have been saved, a
message informs you that you can no
longer save waypoints to the route. Press
the [ENT] key to erase the message. The
route is automatically saved to “LOG” in
the ROUTES menu, under the name of
the first and last waypoint numbers used.
Then, open the ROUTES menu and go to
step 13.
You can manually stop saving waypoints
and save the route by going to step 9.
9. After the desired number of waypoints
have been entered, press the [MENU] key
once or twice to open the menu.
10. Choose ROUTES and then press the
[ENT] key.
11. Choose VOYAGE ROUTE and then press
the [ENT] key.
12. Choose STOP and then press the [ENT]
key.
13. Choose LOG and then press the [ENT]
key.
14.“MOVE?” is selected; press the [ENT] key.
The route is moved from “LOG” and is
registered under the next sequential route
number.
15. Press the [MENU] key twice to finish.
4.2 Editing Routes
Replacing waypoints in a route
1. Press the [MENU] key once or twice to
display the menu.
2. Choose ROUTES and then press the
[ENT] key.
3. Choose the route to edit.
4. Press the [ENT] key.
5. Place the cursor on the waypoint to
replace.
6. Press the [ENT] key to show the route edit
options.
CHANGE?
REMOVE?
INSERT?
SKIP?
Quit?
Route edit options
7. “CHANGE?” is selected; press the [ENT]
key.
NAME: 001
34
°39.836'N MARK
135
°12.059'E x
10-JAN-02 10:25D
TTG 02H00M ETA: 12:25
Exit?
Waypoint attribute edit screen
8. NAME is selected. Press the [ENT] key.
Use the cursor pad to enter waypoint
name.
9. Press the [ENT] key.
Note: If the name entered at step 8 does
not exist, the window shown below
appears. Choose “CREATE?”,
“RENAME?” or “Quit?” as appropriate and
then press the [ENT] key.
CREATE?
RENAME?
Quit?
Waypoint name options
10. Choose “Exit?.”
11. Press the [ENT] key.
12. Press the [MENU] key twice to finish.