Filter
Top Products
-
2
.
14-
2.8 Adjusting Brilliance of Plot Marks
1. Press the RADAR MENU and [0] key to show the FUNCTIONS 2 menu.
2. Press the [9] and [0] key to show the BRILLIANCE 2 menu.
3. Press the [2] key to select PLOT BRILL.
4. Further press the [2] key to select (or highlight) a desired brilliance level.
5. Press the ENTER key to confirm your selection followed by the RADAR MENU key to
close the BRILLIANCE 2 menu.
Note:
Refer to paragraph 1.37 for the BRILLIANCE menu screen.
2.9 Displaying Target Data
The ARPA mode (with built-in ARP-26 optional board) provides the full functionality of
ARPA as required by the IMO Resolution A.823(19) and IEC 60972-1, including display of
range, bearing, course, speed, CPA and TCPA of all plotted targets. Data on 3 targets may be
displayed on the text area at a time.
In head-up and head-up true bearing modes, target bearing, course and speed shown in the
upper-right target data field become true (suffix "T") or relative (suffix "R") to own ship in
accordance with the true/relative vector setting. In north-up, course-up and true motion modes,
the target data field always displays true bearing, true course and speed over the ground.
Place the cursor on a desired target and press the [TARGET DATA] key. Target data display
is as below.
RNG/BRG (Range/Bearing): Range and bearing from own ship to the selected target with
suffix "T" (True) or "R" (Relative).
CSE/SPD (Course/Speed): Course and speed are displayed for the selected target with suffix
"T" (True) or "R" (relative).
CPA/TCPA: CPA(Closest Point of Approach) is the closest range a target will approach to
own ship. TCPA is the time to CPA. Both CPA and TCPA are automatically calculated.
When the CPA has passed clear of own ship, it is indicated by a TCPA with a negative (-)
sign. TCPA is counted to 99.9 min and beyond this, it is indicate as TCPA> -99.9MIN.