Filter
Top Products
Installing
the
Roof
Panel
3.
Lower the roof panel onto the vehicle, rear edge first,
and place the rear guide pins into the holes in the
roof opening.
4.
Lower the front
of
the roof panel, and align the front
guide pins.
5.
Tighten the rear bolts part way.
I
_____~~
NOTICE:
If you tighten bolts that are improperly started,
the threads can become stripped. Be sure all bolts
are properly started before you tighten them.
1.
Park on a level surface, set the parking brake firmly
and shift an automatic transmission into
PARK
(P).
Shift
a
manual transmission into REVERSE
(R).
Lower both windows, turn the ignition key to LOCK
and move both sunshades to the side.
2.
If
the roof panel is stored in the rear area, remove it
by reversing the steps under “Storing the Roof
Panel” above.
6.
Use the ratchet to start the front bolts.
If
the bolts
are
hard to start, tighten the rear bolts some more.
Holding down the panel on the outside will also
help.
7.
Fully tighten the rear bolts, then the front bolts.
If
you hear a popping noise when you drive, the bolts
may not be tight enough. Be sure to tighten them
securely.