Filter
Top Products
NOTICE:
To
help avoid damaging the hardtop when not in
use:
Store the hardtop in its normal position,
0
Store hardware and trim panel with the
resting on its mounting brackets.
hardtop.
12. Connect the rear window defogger electrical
connectors.
To
Install
Your
Convertible Hardtop
1.
Park on a level surface, set the parking brake firmly
and shift an automatic transmission into PARK
(P).
Shift a manual transmission into REVERSE
(R).
Lower both windows and sunshades. Turn off the
radio to lower the power antenna and turn the
ignition key to LOCK.
2.
Disconnect both rear window defogger electrical
connectors behind the lock pillar.
3.
Lower the convertible top. Refer to “Convertible
Top” in the Index.
This procedure will require the use
of
the storage
compartment lid release button behind the dnver’s
seat or the center console release switch. The fuse that
enables these releases is not installed at the assembly
plant and should be in your center console. See
“Instrument Panel Fuse Block” in the Index for
location
of
the
fuse.
The fuse is labeled HATCH
(45).
4.
With one person on each side, carefully position the
hardtop over the vehicle. Lower the hardtop slowly,
aligning the rear bolt spacers onto the bezels, and
front conical nuts into the tapered receivers. Realign
the hardtop, if necessary.
NOTICE:
To help avoid damage, don’t force the rear of the
hardtop down. The hardtop may rest slightly
above the storage compartment lid until the
release lever is pulled. See Step
8
in this
procedure.
2-99