Filter
Top Products
4.
Remove the four screws that attach the console door.
5.
Remove the console door.
6.
Remove the trim plate by pulling up and back.
7.
Disconnect the plug by pulling forward on the plastic
locking tab and pull the plug into the console.
The plug has three separate wires:
0
The orange wire connects to the battery.
The pink wire connects to the ignition. Power is only
0
The black wire connects to the ground.
available in RUN.
NOTICE:
When using the accessory plug:
0
0
0
0
Don’t splice wires directly into the
accessory plug wire.
If
done incorrectly,
splicing might cause damage to your
electrical system.
The maximum load
of
any electrical
equipment should not exceed
10
amps.
Be sure to turn
off
any electrical equipment
when not in use. Leaving electrical
equipment on for extended periods can
drain your battery.
Do
not use this plug
if
the electrical
equipment requires frequent connecting
and disconnecting. This may cause
excessive wear on the accessory plug and
damage your electrical system.
After you’ve installed the electrical equipment, put the
trim panel and console lid back in place and install the
screws
.
2-63