Filter
Top Products
4.
Fill
with
the proper mix. Add coolant until
you
see
a
steady stream
of
coolant coming from the bleed
valve.
5.
Close the bleed valve.
6.
Continue to fill the coolant high fill reservoir up to
the base of the filler neck.
7.
Rinse or wipe the spilled coolant from the engine
and compartment.
8.
Start the engine and
allow
it
to run
in
idle for
approximately four minutes.
By
this time, the
coolant level inside the coolant high fill reservoir
will be lower. Add more
of
the proper mix through
the filler neck
until
the level reaches the
base
of
the
filler neck.
9.
Shut the engine off
and
replace the pressure cap. Be
sure the arrows
on
the cap line
up
like this.
5-25