Filter
Top Products
5.
6.
7.
8.
9.
LO.
Move both seatbacks forward. Slide the lock pillar
bracket into the receiver bracket until the scribed
line
is
even with the lower edge of the receiver
bracket.
Connect the electrical connectors and make sure
they
are
inside the vehicle.
Insert the two upper bolts into both receiver
brackets. You may have to lift the hardtop slightly
to install the lock pillar bracket.
If
the hardtop hasn’t lowered into position, pull the
release lever behind the driver’s seat under the
storage compartment lid.
Secure but don’t tighten the rear corner bracket
bolts using the ratchet.
Tighten the front bolts using the wrench.
11.
Insert the lower bolt into the bottom flange
of
the
lock pillar brackets and tighten. Install and tighten
the remaining bolts into the lock pillar brackets.
12. Using the ratchet, tighten the rear corner bracket
bolts.
Do
not over-tighten these bolts.
13.
Slide
the
rear trim panel
in
place.
14. Remove the
HATCH
(45)
fuse. Store it in the center
console while the convertible hardtop is
in
use.
(This will prevent accidental unlatching
of
the
storage compartment lid.)
!
2-100