Chevrolet 1995 Automobile User Manual


 
To
Increase Speed While Using Cruise Control
There are two ways to go to a higher speed. Here’s the
first:
Use the accelerator pedal to get to the higher speed.
Push the button at the end of the lever, then release
the button and the accelerator pedal. You’ll now
cruise at the higher speed.
Here’s the second way to go to a higher speed:
Move the cruise switch to
R/A.
Hold it there until
you get up to the speed you want,
and
then release
the switch.
To
increase your speed in very small amounts, move
the switch to
R/A
for less than half a second and then
release it. Each time you do this, your vehicle will
go
about
1
mph
(1.6
km/h)
faster.
To
Reduce Speed While Using Cruise Control
There are two ways to reduce your speed while using
cruise control:
Push in the button at the end of the lever until you
reach the lower speed you want, then release it.
0
To
slow
down in very small amounts, push the
button for less than half a second. Each time you
do
this, you’ll
go
1
mph
(1.6
km/h)
slower.
Passing Another Vehicle While Using Cruise Control
Use the accelerator pedal to increase your speed. When
you take your foot off the pedal, your vehicle will slow
down to the cruise control speed you set earlier.
Using Cruise Control on Hills
How well your cruise control will work on hills depends
upon your speed, load, and the steepness
of
the hills.
When going up steep hills, you may have to step on the
accelerator pedal to maintain your speed. When going
downhill, you may have to brake or shift to a lower gear
to keep your speed down. Of course, applying the brake
takes you out of cruise control. Many drivers find ths to
be too much trouble and don’t use cruise control on
steep hills.
To
Get Out
of
Cruise Control
There are several ways to turn
off
the cruise control:
Step lightly
on
the brake pedal or push the clutch
pedal, if you have a manual transmission;
OR
0
Move the cruise switch to
OFF,
To
Erase Speed Memory
When you turn off the cruise control or the ignition,
your cruise control set speed memory is erased.
2-45